Pyle Home PDIWS8 8-Inch In-Wall High Power Subwoofer

Pyle Home PDIWS8 8-Inch In-Wall High Power Subwoofer Reviews

More Picture

Pyle Home PDIWS8 8-Inch In-Wall High Power Subwoofer Feature

• 8'' In-Wall High Power Subwoofer - Cut-Out Dimensions: 7 7/8'' W x 7 7/8'' H x 3 1/2'' D
• 2.0'' High Temperature Dual Voice Coil
• Power Handling: 150W RMS, 300W Peak
• Frequency Response: 60Hz- 4 KHz
• 4-8 Ohm Impedance

The Pyle Home PDIWS8 in-wall subwoofer system delivers bass to any room in your home or office without cluttering floor space. Included in the kit is the mounting hardware for installation, and a template for existing construction. For new construction, consider one of Pyle's mounting brackets for precise installation.

Go tO Store Now !!

More Products

• Pyle Home PDIWCS56 Dual 5.25-Inch 2-Way In-Wall Center-Channel Speaker System
• 3 Port Smart HDMI Switch

More Reviews

Don't waste your money - Bobby Dunn - SE KY
This is a pretty bad setup. I don't know where to start, but first off it is no subwoofer. There is no crossover anywhere so they expect it to be hooked up to a dedicated amp. There is also only one speaker, even though they show 2 in the picture. The installation was terrible. I have other Pyle inwalls and thought they were fine, sound was OK, install was as it should be. The clips on these mounts are all wrong. You cannot blind install like you are suppose to because the clips just spin when you try to tighten them (the slots let the clips go up too far). I ended up turning the clips backwards to make them shorter and managed to make them work. The screws are terrible, soft and will strip the head out very easy. They are as cheap as any I have ever seen. The sound is not very good either. I had a an old seperate sub that was part of a kit that I wanted to get rid of to make room but it sounds much better than the Pyles, I have just decided I have to live with the size of the old sub. Now I have a hole in the wall with a cover.



Oct 29, 2010 15:13:04